Quality

The following are the main procedures of quality control in our company.
1、Supervise the factory to establish a sound job responsibility system.
2、Supervise the factory to do a good job of civilized production seriously.
3、Supervise the factory to do a good job of preparation before production.
4、Supervise the factory to organize good equipment maintenance work.
5、To do a good job in quality management of materials and supplies.
6、Use system documents to supervise and inspect quality activities and try to count all kinds of information.
7、Supervise the factory to improve the quality of packaging.

1、Supervise the factory to establish a sound job responsibility system
Timely formulation or revision and strict implementation of the operating procedures and compliance with production discipline.

2、Supervise the factory to seriously carry out civilized production
In particular, maintain good production order, reasonably equip the work station apparatus and ensure the smooth flow of production channels. Greening the environment to prevent pollution and dust.

3、Supervise the factory to do the preparation work before production
Reasonable arrangement of production operation plan.

4、Supervise the factory to organize the equipment maintenance work
Keep the technical condition of the equipment in good condition. The quality standard to be achieved by the repaired equipment. To improve the work equipment, to ensure the accuracy quality of work, cards, measurement and cutting tools.

5、To do a good job in the quality management of materials and supplies
Strictly check and accept the incoming materials, and return or reject the materials that are unqualified and not in accordance with the contract. Strengthen the storage of materials to prevent damage and deterioration. Improve service quality and ensure timely supply. Where the products are purchased and sold by the material department, the material department should be responsible for the quality of materials and materials to the end.

6、Use the system documents to supervise and check the quality activities and try to count all kinds of information
Non-conforming factors (non-conformity refers to non-conforming requirements, divided into non-conforming products and non-conforming items) will always be found more or less, the important thing is what is the nature of the non-conforming factors found.

If it is a general non-conformity, it has little impact on the quality of the final product, this non-conformity is relatively easy to correct;

if it is a serious or systematic non-conformity, it is important to pay great attention to, because it will affect the normal operation of the system, so that the final product defects or scrap.

Therefore, the quality system is set up to supervise and inspect the quality activities, so that the non-conforming factors can be cleared out in time, and the reasons for them can be identified, and the corresponding corrective and preventive measures can be actively adopted to solve the non-conforming factors completely in order to prevent the recurrence.

When a nonconformity is found, it is necessary to control it, and it is required to analyze the causes, to learn from the past, to prevent the same problem from occurring again, which is the corrective measures.

On the basis of the development of corrective measures, the factors that may lead to such non-conformity (human, machine, material, method, environment, measurement) to specify the constraints (system documents, standards, etc.) to ensure that the fluctuations of these factors do not exceed the scope of the constraints, which is the basic content of the prevention of non-conformity.

Corrective and preventive measures are followed up and checked, and closed-loop zeroing management is implemented, so that the quality of the production process can be improved.

Even so, some factors will fluctuate, and it is impossible to recognize the causes of fluctuations very comprehensively and accurately at one time, which requires constant identification of the causes in the process monitoring, finding one, eliminating one, so that fluctuations towards the goal of zero is constantly approaching.

7、Supervise the factory to improve the quality of packaging
To develop packaging standards according to the characteristics of the product, strictly according to the standard packaging and inspection, the product packaging is not qualified must be reworked.

To continuously improve the product decoration, to achieve beautiful and generous.